I had a few issues, but openbuilds support was excellent and had me running in no time. The kit came with all the wiring, I added two additional limit switches for end stops. For that I also used the Openbuilds controller: Controller I pretty much came with everything needed minus the controller board. I went with the Openbuilds Acro 1010 Acro 1010. This is the part that will move the laser around and control the laser power. I am sure this could be a few dollars per print, plus you will ruin the prints in the process of cutting them out.ġ) Could handle a full sheet of foam board.Ģ) Could be repeated quickly and with no cost other than the foam board.ģ) could be used with a older laptop computer. Hope your knife does not slip while you try to follow the lines.ģ) Alternatively you could take the PDF plans to a printing place that has the ability to print them full size for you.

While Flite test graciously provides FREE plans for all their kits, it can be time consuming and costly to go that route.Ģ) Print out the TILED plans on your own printer, tape and glue them to the foam board. I wanted to be able to cut my own FT aircraft. That is what Flite test uses, but they are expensive when you get into a size that can handle a full sheet of foam board. I will be adding to this, may take a day or two to complete.įor starters, if you want to laser out foam board, and have the money, get a Co2 laser.

Lightburn software cost